Menu:
Mechanical Fixings
Ferazzi Marble also provide various kinds of Mechanical fixings, which are detailed below. If you are interesting in purchasing any of the fixings shown on this page please contact us using the enquiry form or by getting in touch via telephone.
Restraints for Stone Cladding
Reference should be made to BS 8298 : 1994 “Design of natural stone cladding”, when selecting ties for restraining stone cladding.
Each stone will normally be restrained in four places, two at the top and two at the bottom. The restraints should be located in pre-formed mortices or holes positioned in the centre of the thickness of the stone panel, and located at 1/4 points for half bonded stones and 1/5 points for stack bonded stones. Restraints should be kept at least 75mm from any corner with the peripheral distances between any two restraints not exceeding 1200mm. The embedment of restraint dowels and lips into the stone should be at least 20mm. To achieve this lipped ties, (LPBs) have a 25mm downstand and dowelled ties (DPBs and YPBs) have 60mm long dowels.
Approved Document E
Ancon flat ties have a measured dynamic stiffness of <113MN/m³ and therefore meet the performance requirements of building regulations Part E for use in external masonry walls.
Drip Positions
Due to the wide varieties of design cavity and stone and insulation thickness, it is not possible to standardise the position of any required drip. If a drip is required (e.g. YDB) please specify the position clearly, indicating from which end of the tie the measurement is taken.
Standard Stone Fixings
|
YDB |
YPB |
YP21 |
MP21 |
|
MDS |
MPB |
LP21 |
MPB |
|
LPL |
ZDS |
DP21 |
DPB |
|
DDS | |||
Wire Ties
Wire ties are manufactured from 3mm and 5mm diameter wire for the fixing of thin marble.
--------
Ancon 150
 | This grout-in masonry tie restrains 20 to 30mm thin facings and is suitable for cavities up to 60mm wide. The 12 x 2mm corrugated body provides optimum bond in a 12x90mm hole. The 50 x 3mm dowel is supplied loose. |
Ancon Push-Off
Bolt
 | This fixing provides the centre of stone panels with additional resistance to the effects of impact loads, blast loads and positive wind pressure. Its mechanical expander fixes securely into the inner leaf while the neoprene pad cushions the external stone panel and prevents rattling. Lengths to suit 100-200mm. |
Ancon 2000
 | Ancon 2000 restraint fixings are simple and secure method of fixing thin facing slabs (20-40mm). |
If you are interested in these mechanical fixings then please contact us using the online enquiry form.